Advertisement
5
INSTALLATION (continued)
Step 2: Configure each adaptor. Using a computer and an unmanaged switch, log in to each adaptor one
at a time using a web browser pointed to
Alert messages, then use the default Admin ID "aiphone" and Password "aiphone". In the Admin tab do the
following (See Figure 2, below "Web Interface, Admin tab")
a.
Click on the [Setting] button next to Administrator
Registration to change the Admin ID and Password
(highly recommended).
b.
Click on the [Setting] button next to User Registration to
add up to 9 User IDs and Passwords (it is highly
recommended to add at least 1 User ID and Password).
c.
Click on the [Setting] button next to Email to enter an
originating email address and mail server settings the
adaptor will send an email from whenever a door call,
sensor detection, or system start up occurs. Optional
(Some email providers are not supported).
d.
Click on the [Setting] button next to Sensor IN / Option
OUT to configure the inputs to be N/O or N/C and the
Output duration to anything from 0 (momentary) to 600
seconds (Optional).
e.
Click on the [Setting] button next to Network and change
the IP address, subnet mask and ports as needed,
Update Encryption Key File, change the name, and
video settings. Required, (See Figure 3 to the right
"Network Settings").
Click the [Save] button and then the [Reboot] button to restart
the adaptor (this will take up to 2 minutes) and repeat these
steps with the next adaptor until every adaptor has a unique IP
address and valid subnet mask as determined in Step 1.
Step 3: Register each adaptor. Install JKW-IP software on an
Admin or User PC, using the supplied CD or download it from
http://www.aiphone.com, and update the computer's IP address
and subnet mask to match the adaptors' subnet as needed.
The software needs to know how to reach the adaptors,
and needs to have the Connection password to connect and
communicate. To register an adaptor to connect and
communicate with the JKW-IP software:
a.
Right-click the name of the adaptor and choose
Connect from the drop down menu (see Figure 1 on
page 3 "JKW-IP Program window").
b.
Provide IP address, Connection password (default is
"aiphone"), and an Admin or User ID and password (see
Figure 4 to the lower right "Adaptor Registration").
Click [Save] and repeat for each adaptor and each computer
(see "Advanced Installation Techniques" section on page 8 for a
method of copying these settings to other PCs).
Pg. 4
https://192.168.0.30
and click [OK] or [YES] for the any Security
Figure 2: Web Interface Admin tab
Figure 3: Network settings
Figure 4: Adaptor Registration
Advertisement
