Advertisement
6
OPERATIONS (continued)
6.3
Computer to Master communication
The JKW-IP software and the physical JK-1MD/JK-1MED master stations can communicate via an intercom
feature, also called Room to Room calling or Computer to Master calling.
The following occurs when receiving a call
a.
The call tone sounds, no image is displayed (the camera door station is not involved).
b.
The status icon in the Status display will change to an orange square and a message will read
"1 CALL ROOM ST".
c.
A message will appear in the Message display that will read
<Adaptor Name> CALLING FROM ANOTHER ROOM ST
The [Talk] button is then available, click to start a conversation, if ignored the system will eventually time out.
Press [OFF] to end the conversation.
To place a call, select the adaptor whose Master you wish to communicate with and press the [Call]
button. If none are selected, the pre-tone will go out to every master, and the first JK-1MD/JK-1MED master
to push their Talk button will be able to communicate. Press [OFF] to end the conversation.
6.4
Entrance monitoring
The JKW-IP software can monitor a door station without first being called. Select an adaptor from the
Adaptor display and then click the [Monitor] button. The JKW-IP software will display video, receive audio
from the door station, and the status icon and Message displays will reflect the station's Monitor status.
Press [TALK] to talk and press [OFF] to end monitoring and return to Standby.
6.5
Sensor Detection from Connected Equipment
When the Sensor input receives a change in state, the following occurs:
a.
The Sensor Detection Tone plays, unless turned off in the [PC Settings] window, and the status icon
for the input will turn blue for 30 seconds or until it is turned [OFF].
b.
The Message display will read <Adaptor Name> EXTERNAL INPUT <No.> for 30 seconds.
6.6
Recording and Playback
Settings for recording can be adjusted in the PC Settings window
(See Figure 12 to the right "PC Settings window").
Automatic Image Recording - When a call is received from a
door station, the door station images are recorded automatically,
unless the JKW-IP software is currently in conversation with
another door station. When communication starts or the call ends,
the automatic recording stops.
Automatic Video Recording - When a call is received from a door
station, the door station's video is recorded if enabled in the
[PC Settings] window. Video recording stops when the call is
answered and when the call ends (see Figure 5 on page 5 "PC
Settings window").
Manual Image Recording – While communicating with a door
station, press the [O] (Record) button. The program will record one
image every time it is pressed.
Manual Video Recording – While communicating with a door
station, press the [O] (Record) button. Recording will continue until
the conversation or monitoring ends and the adaptor goes back
into Standby.
Playback – While the JKW-IP program is in Standby, press the
[|>] (Play) button, which opens a window allowing the operator to
select an Adaptor and view recordings.
Figure 12: PC Settings window
Pg. 7
Advertisement
