Panasonic EP-MAG1 Operating Instructions Manual page 68

Applications and flows of different massage actions
Body scanning
Body scanning is where the massage heads move along the shoulder position detected, the body shape including height is
estimated, and a massage is made to suit the body shape.
●
During body scanning,
●
Body scanning height range is about 140 cm – 185 cm.
Automatically
To massage
position
Body scanning
●
Even during the tapping action, when you press
●
To estimate the approximate height based on the shoulder position, the legrest may automatically adjust its angle so that the
sole of the foot touches.
●
If the shoulder position is greatly shifted, one press of
firmly and press the button to start again.
EN22
will flash.
Sit back and lean gently back so that your head touches
the pillow.
●
For adjustment of the position of the
pillow. (Page EN17)
Raised approx. 75 °
About 30 seconds after the body scanning starts,
the massage head will lower slowly to the shoulder
position and start the tapping.
●
With the body scanning sound "beep-beep ...", the massage head will rise up the spine
to the vicinity of the neck.
●
Manual action (for example, "背部" or "腰部") performs a simple sensing, but the
massage head doesn't rise up to the shoulder.
●
The massage head protrudes.
(It will rise again if it does not match the shoulder position and repeat the action to adjust the shoulder position.)
●
Seat surface air operates to prevent the body from moving during scanning.
Massage head
Tapping
action
■ To adjust the shoulder position
During tapping action (about 12 seconds), to adjust the height of the shoulder using the
POSITION button, push .
Moves approximately
1.2 cm up or down for
each press.
, body scanning will end and massage will start.
will stop the action. Rest your shoulders back against the backrest
(Continued)
Reclined approx. 20 °
●
If you have reclined deeper than
the best massage position, it
does not automatically recline.
Do not move your head
from the pillow until tapping
action begins!
It will not be able to accurately
detect the shoulder position
Too high
Correct position of
the shoulder
(The point where the
tapping action should
be felt.)
Too low