Support Kit For Downdraft Installation Procedure - Wolf CT15G-2 Technical & Service Manual

Installation Information

SUPPORT KIT FOR DOWNDRAFT INSTALLATION PROCEDURE

These instructions contain procedural information to install the Integrated Cooktop Support Kit for downdraft ventilation
installations.
NOTE: This kit does not include the Filler Strip Kit Assembly. Please order Kit Model number: 803386.
1. Locate and center Rear Bracket Support (1) in downdraft cutout as shown.
2. Position Rear Bracket Support (1) so that top surface is flush with counter top. You may need a straight edge to
assist in locating the bracket at the correct height.
3. Mark center of elongated slots of Rear Bracket Support (1) at both ends on countertop.
4. Mark center of elongated slots of Filler Strip Bracket (not included) on front of cooktop cutout.
5. Using a 3/32" drill bit, drill a ¾" deep pilot hole for the #6/32 mounting screws (3).
PLEASE CONSULT WITH THE COUNTERTOP MANUFACTURER/INSTALLER FOR THE PROPER METHOD OF
INSTALLING SCREWS INTO THE INSIDE EDGE OF THE COUNTER TOP. DAMAGE MAY OCCUR IF THE
PROPER METHODS ARE NOT USED.
6. Install Downdraft into countertop opening, but do not secure in place at this time.
7. Secure Rear Bracket Support (1) and Filler Strip Bracket (not included) to countertop using items (2 & 3).
8. Install Integrated cooktops into corresponding openings.
9. Position Filler Strip (not included) into Filler Strip Bracket (not included) and install three #10-24 nuts, but do not
tighten.
10. Align and adjust cooktops, downdraft and filler strip in counter top opening and then tighten cooktop hold
down clamps, filler strip nuts and secure downdraft per installation instructions.
G G A A S S C C O O O O K K T T O O P P - -
G G A A S S C C O O O O K K T T O O P P - -
Filler Strip
Not Included
CENTER OF
CUTOUT
Fig. 3-14. Support Kit for DownDraft Ventilation Installation
2 2
2 2
1
2
3
Not Included
3-8
S S E E R R I I E E S S
S S E E R R I I E E S S
Filler Strip Bracket
Not Included
2