Quantum SuperLoader 3A Series User Manual page 52

Quantum SuperLoader 3A Series User's Guide
A check mark appears after the currently enabled mode.
3 Do one of the following:
• To leave the
• To change the
want for the autoloader, selecting the appropriate check box, and
then click
submit
The message
change. Enter To Continue
• To continue with the change, press
power cycle the tape autoloader and reconfigure the ISV app.
displays.
System Time
The system time is displayed by On-board Remote Management and is
used internally for logging events and errors (see
page 12).
The system time must be reset each time the autoloader powers up. The
time is reset automatically if a time server is configured (see
Remote Management Ethernet Port
be set manually from the front panel or through On-board Remote
Management. The time zone setting is not lost when powered off.
Note: Whether connected to a time server or not, the autoloader
automatically corrects for daylight savings time if the time was
set using On-board Remote Management. If the time was set
from the front panel of the autoloader, you must correct for
daylight savings time manually.
To set the system time:
1 Using the first drop-down list next to
hours difference between your local time and Greenwich Mean Time
(GMT).
For example, if you live in Colorado, the time difference is
Note:
–6 hours in the summer and –7 hours in the winter.
2 Below the
Time Zone
Chapter 3 On-board Remote Management
mode unchanged, press
Magazines
configuration, scroll to the setting you
Magazines
. These settings include
This will require a power cycle and ISV configuration
is displayed.
on page 9). Otherwise, the time must
Time Zone
field, select the current
Configurations Page
.
Esc
, , and
Both Right
. The message
submit
Setting the Time
Using the
, select the number of
drop-down list.
Month
.
Left
Please
3
on
38