Quantum SuperLoader 3A Series User Manual page 51

Quantum SuperLoader 3A Series User's Guide
To set :
Auto Clean
1 From any page, click the
screen displays.
2 Scroll to
Cleaning Tape
If a check mark appears in the box next to
enabled. To disable
mark. If no check mark appears in the box next to
option is disabled. To enable
mark.
3 In the
Cleaning Tape Location
where you installed the cleaning tape. If
cleaning is managed by the backup package you have installed
instead.
4 Click .
submit
Magazines
This setting is used to report the number of storage elements and the
element address to the host. This setting must match the physical
configuration in order for correct information to be reported. This setting
only affects the information reported to the host. This setting does not
affect the access to magazine slots from the front panel or On-board
Remote Management. Those interfaces are based on the physical
configuration.
When configured for
storage elements to the host. This allows the removal and reinstallation of
magazines without affecting what is reported to the host. When
configured for or
Left
storage elements to the host.
The element addresses vary depending on which magazine is configured.
If or is selected, and both magazines are physically installed,
Left Right
the front panel and On-board Remote Management allow the user access
to the other magazine, but the host will not have access.
To set the
Magazines
1 From any page, click the
screen displays.
2 Scroll to
Magazines
Chapter 3 On-board Remote Management
Configuration
.
, click the box to remove the check
Auto Clean
Auto Clean
field, select the appropriate slot location
magazines, the autoloader always reports 16
Both
, the autoloader will always report eight
Right
option:
Configuration
. The options display.
Magazines
Configurations Page
heading. The
Configuration
, the option is
Auto Clean
Auto Clean
, click the box to enter a check
is disabled,
Auto Clean
heading. The
Configuration
, the
3
37