THOMSON grass valley VIPER LDK 5490 User Manual page 58

- Select TOP to bring you back to the Main menu.
- Select PREVIOUS to go back to the menu that you were in before
the current one.
The Install menu above shows the items displayed when you first enter
the menu and the other items that are available by scrolling up or down
with the Rotary control.
Leaving the Systems Menu
If you are deep within the menu structure, follow these steps to leave:
a. If necessary move the cursor to the leftmost column with the Select
button.
b. Scroll upwards with the Rotary control until the cursor points to
TOP (this is the Main menu).
c. Press the Select button. The cursor now points to the Menu off item
of the Main menu.
d. Press the Select button to leave the Systems menu.
This is the recommended way of leaving the System menu.
If you do not use the menu it disappears after a few seconds. (This
delay can be programmed in the VF menu.) However, when you press
the Select button again you enter the System menu at the last position
of the cursor and not at the top of Main menu.
To prevent confusion the next time you enter the System menu, it is
advisable to leave the System menu by returning to the Main menu
(TOP) and selecting Menu off.
6-4
All manuals and user guides at all-guides.com
TOP
PREVIOUS
Format
Aspect ratio
Output mode
Disable camera
IR receiver
MENU: INSTALL
OnAir lamp
Notch
Exposure
Gain preset
FilmStream mode
1080i
16:9
FilmStr.
Off
Off
On
On
Viper