THOMSON grass valley VIPER LDK 5490 User Manual page 19

All manuals and user guides at all-guides.com
Attach a lens to the camera head as follows:
a. Ensure that the lens locking ring (1) is in the unlocked position -
turned counterclockwise.
b. Remove the dust protection cap (2).
c. Slot the lens into the lens mount (3).
Do not attach a lens weighing more than 5 kg to the
d. Turn the lens locking ring (1) clockwise to lock the lens in place.
e. Connect the lens cable, if any, to the lens connector (4) at the right
side of the camera.
f. Place the lens cable into the bottom clip at the front of the camera
and clip (5) located at the side. (Pull and twist clip (5) to open it.)
g. In the Lens menu, set the Lens Type item to Std for a standard lens
or to WA for a wide angle lens.
h. Select the lens manufacturer in the Lens menu. Select Ang for
Angenieux, Can for Canon, Fuj1 or Fuj2 for Fujinon or select Other
for other lens manufacturers.
Note:
Always mount the dust protection cap when the lens is not connected
to the camera.
When a new lens is fitted to the camera it may be necessary to carry
out some adjustments to optimize its use, for example, back focus. For
more information about these adjustments refer to the lens
manufacturer's documentation.
Assembling the Units
Caution
camera without a support.
FilmStream mode 2-3