Table of Contents
Advertisement
9.
Slide the optical drive through the front bezel all the way into the bay so that it locks in place (1),
then connect the power cable (2) and data cable (3) to the rear of the drive.
10.
Connect the opposite end of the data cable to one of the light blue SATA connectors on the
system board.
NOTE:
drive connectors.
11.
Replace the front bezel if it was removed.
NOTE:
from HP. Install the bezel trim piece in the front bezel before installing the front bezel.
12.
Replace the computer access panel.
13.
If the computer was on a stand, replace the stand.
14.
Reconnect the power cord and any external devices, then turn on the computer.
15.
Lock any security devices that were disengaged when the access panel was removed.
32
Chapter 2 Hardware upgrades
Refer to
System board connections on page 13
An optional bezel trim piece that surrounds the front of the optical drive is available
for an illustration of the system board
Advertisement
Table of Contents
