Pushing The Machine By Hand - Toro 74790 Operator's Manual

1. Anti-scalp roller
2. Bolt
Pushing the Machine by
Hand
Important:
Always push the machine by hand. Do
not tow the machine, because damage may occur.
This machine has an electric-brake mechanism. To
push the machine, the ignition key needs to be in the
position. The battery needs to be charged and
RUN
functioning for the electric brake to be disengaged.
Pushing the Machine
1. Park the machine on a level surface and
disengage the blade-control switch.
2. Set the parking brake, shut off the engine, and
wait for all moving parts to stop before leaving
the operating position.
3. Locate the bypass levers on the frame on both
sides of the engine.
4. Move the bypass levers forward through the key
hole and down to lock them in place
5. Turn the ignition key to the O
disengage the parking brake.
Note:
Do not start the machine.
Figure 18
3. Flange nut
4. Hole spacing
(Figure
position and
N
g010233
1. Bypass-lever locations
2. Lever position for
operating the machine
6. When you are finished pushing the machine,
return the key to the
draining the battery charge.
Note:
If the machine fails to move, the electric brake
may still be engaged. If necessary, the electric brake
can be released manually; refer to
Electric Brake (page
Operating the Machine
Move the bypass levers rearward through the key hole
and down to lock them in place as shown in
Note:
Ensure that the bypass levers are pull rearward
the full length of travel.
19).
25
Figure 19
3. Lever position for pushing
the machine
position to avoid
STOP
Releasing the
41).
g017303
Figure 19.