Table of Contents
Advertisement
IMPORTANT:
cover for proper cooling of internal components during operation.
8.
To install a half-length expansion card, hold the card just above the expansion socket on the system
board then move the card toward the rear of the chassis (1) so that the bottom of the bracket on the
card slides into the small slot on the chassis. Press the card straight down into the expansion socket on
the system board (2).
NOTE:
seated properly in the expansion card socket.
9.
To install a full-length expansion card you must rotate the drive cage up to allow room for installing the
card.
a.
Disconnect the power and data cables from the rear of the drives in the drive cage.
b.
Rotate the drive cage up (see
50
Chapter 4 Removal and replacement procedures
After removing an expansion card, you must replace it with a new card or expansion slot
When installing an expansion card, press firmly on the card so that the whole connector is
Drive cage on page
28)
Hide quick links:
Advertisement
Table of Contents
