Installing The Canopy; Installing The Blades - Hunter Fitzgerald Installation Manual

1886
Swing the fan up to align the canopy screw
holes with the mounting holes on the ceiling
plate.
Note: The slots in the canopy must
remain engaged while swinging the
canopy for alignment.
Note:
Fan style may vary.
Insert grommets found in the
holes in the blades, then secure each blade to a blade arm
with screws found in the hardware bag.
x10
Blade Arm Screw
bag
Repeat x5
5
Ceiling Bracket

Installing the Canopy

Hold the canopy up with the screw holes
aligned. Partially install two canopy screws,
found in the hardware bag, into the
holes opposite the ceiling plate hooks.

Installing the Blades:

hardware bag into the
Repeat x5
Lightly attach the blade arms to the motor with
screws found in the hardware bag, then
securely tighten after both screws are attached.
Hanging Fan
2 of 3
Canopy
bag Screws
Note:
Fan style may vary.
Wiring Canopy
bag
Partially install a canopy screw, found in the
hardware bag, between the ceiling plate hooks.
When all the holes are properly aligned, securely
tighten all three canopy screws.
bag
bag
IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
Note:
Fan style may vary.
Blades
1 of 3
Canopy
Screws
x15
Blade Screw
x15
Grommet
Control