Hunter Fitzgerald Installation Manual page 5

We know wiring is hard. Let's make it easier.
Follow these steps to get your fan wired quickly and safely. Follow the route below that best matches your wall switch
setup. If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a quali ed electrician.
You are going to need these:
4 Wire Nuts (these are in the
Have a single switch?
Follow these steps:
Connect the grounding
wires (green, green/
yellow stripe, or bare
copper) coming from the
ceiling and ceiling plate.
WARNING
The ceiling fan must be grounded. If the
ground wire for the installation site is not
present, immediately STOP installation and
consult a quali ed electrician.
Have dual switches?
Follow these steps:
Connect the grounding
wires (green, green/
yellow stripe, or bare
copper) coming from the
ceiling and ceiling plate.
Note:
Fan style may vary.
Ceiling Bracket
bag)
Hanging Fan Wiring
Wiring the Fan
Hunter Pro Tip:
Black
WARNING
All wiring must be in accordance with
national and local electrical codes ANSI/NFPA
70. If you are unfamiliar with wiring or in
doubt, consult a quali ed electrician.
Black
Canopy
Here is how to connect the wires:
Push the bare metal ends of the wires together and slide a wire
nut over them. Then, twist the wire nut clockwise until tight.
Give it a gentle pull to make sure none of the wires are loose.
Connect the white
(grounded) wire
White
from the ceiling
to the white wire
from the fan.
Connect the black wire
(ungrounded) from the
ceiling to the black and the
blue wires from the fan.
Hunter Pro Tip:
Have extra wiring?
Turn the wires upward and push them carefully
back through the hanger bracket into the outlet
box. Spread the wires apart, with the grounded
wires on one side of the outlet box and the
ungrounded wires on the other side of the outlet
box. Make sure that the wires are still attached
to the wire nuts.
Connect the white
(grounded) wire
from the ceiling
to the white wire
White
from the fan.
Connect the black
(ungrounded) wire from
the ceiling to the black
wire from the fan.
Connect the second
ungrounded (light) wire
from the ceiling to the
blue wire from the fan.
Blades
1886
x4
bag
Wire Nut
x4
bag
Wire Nut
LPSMKSTKPC-01 r092421
4
Control