Table of Contents
Advertisement
1886
You probably bought this fan with a location in mind. Let's check below to make sure it is a good fit.
Check the room dimensions:
30 inches
from blade tip to
nearest wall or
obstruction
from bottom edge
of blade to the
You have two options for installation. Pick which one works best for your location. Remove any existing
bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan's box.
Do this first!
WARNING
To avoid possible electrical shock, before
OFF
installing your fan, disconnect the power by
turning off the circuit breakers to the outlet
box associated with the wall switch location.
Option 1:
Machine Screws
Use machine screws
(provided with outlet box)
and washers when securing
to existing ceiling fan-rated
outlet box. Make sure it is
securely installed and is
acceptable for fan support of
31.8 kg (70 lbs) or less.
NOTICE
To prevent damage to fan,
ALWAYS lift holding the fan
housing.
3
Ceiling Bracket
Choosing the Right Installation Location
7 feet
floor
Installing the Ceiling Bracket
Hanging the Fan
Raise the fan and align the slots in the
canopy with the hooks on the ceiling plate.
Note: To hang the fan, you must tilt the canopy to
an almost vertical position so that the canopy slots
sit on the ceiling plate hooks.
Hanging Fan
Check the outlet box:
Hunter Pro Tip:
The machine screws are the ones
that came with your outlet box.
Option 2:
Wood Screws
Use wood screws and
washers (included) when
securing to support structure
with approved electrical
outlet box. Drill 9/64" pilot
holes in support structure
to aid in securing ceiling
bracket with hardware found
in the
hardware bag.
Wiring
Canopy
You must be able to
secure the fan to building
structure or fan-rated
outlet box.
bag
x2
Washer
Wood Screw
Place the slots over the ceiling
plate hooks to hang the fan.
Blades
x2
Control
Advertisement
Table of Contents
