Q-See QSDF8204C4-320 User Manual page 18

1. HOLD TIME
This sets the continued recording time after an alarm is triggered. There are
two options: 1 minute and 2 minutes. It also determines the interval between
motion detection events. If the HOLD TIME is 1 minute, if new motion is
detected within this period it will be considered part of the previous event
instead of the start of a new event.
2. CHANNEL
STEP1
STEP2 Press "Enter" key to switch the channel and select.
3. DETECTION
Checking "DETECTION" means to enable motion detection, not checking
means motion detection will not be enabled.
4. SENSITIVITY
This is the sensitivity level of the motion sensors.
The range is from '1' to '8'. The higher the value, the more sensitive.
5. TO REC
If selecting "TO REC", DVR will record when motion is detected. If not, DVR
will not record when motion is detected.
6. ALARM OUT
There are two options: ALARMOUT1 and BUZZER.
•
When ALARMOUT1 is selected and an alarm is triggered, the DVR will
give send signal to the alarm out port.
•
When BUZZER is selected and the sensor is triggered, DVR will give a
buzzer alarm.
When the alarm output is unselected, DVR will not send an alarm.
7. SCHEDULE
This is the schedule for the motion detection. The default schedule is
everyday. Press "SETUP" button to set the motion detection schedule.
8. AREA
STEP1 Move the cursor to "setup".
STEP2 Press "SETUP" button to enter the Area Setup submenu.
It displays the selected detection area (refer to Fig. 3.11). There
are four options:
−
in the picture.
−
−
−
18
QSDF8204 Digital Video Recorder User Manual
Move the cursor to the channel.
ALL: motion anywhere in the area will be detected as shown
CUSTOM: You can select part of the area to be detected.
NULL: No area will not be open to motion detection
BACK: Go back to Motion Alarm Configuration menu.