Wiring The Fan - Hunter Tunley Installation Manual

We know wiring is hard. Let's make it easier.
Follow these steps to get your fan wired quickly and safely. Follow the route below that best matches your wall switch
setup. If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualified electrician.
Connect the black
(ungrounded) wire from
the ceiling to the black
wire from the receiver.
Connect the white (grounded)
wire from the ceiling to both
the white wire from the
receiver and the white wire
from the fan.
bag
Wire Nut
Ceiling Bracket Downrod
WARNING
All wiring must be in accordance with
national and local electrical codes ANSI/NFPA
70. If you are unfamiliar with wiring or in
doubt, consult a qualified electrician.
White
Note:
x4
Fan style may vary.
Hanging Fan

Wiring the Fan

Hunter Pro Tip:
Hunter Pro Tip:
Wiring Canopy
Here is how to connect the wires:
Push the bare metal ends of the wires together and slide a wire
nut over them. Then, twist the wire nut clockwise until tight.
Give it a gentle pull to make sure none of the wires are loose.
Slide the remote
receiver onto the
top of the bracket.
Have extra wiring?
Turn the wires upward and push them carefully back through
the hanger bracket into the outlet box. Make sure that the
wires are still attached to the wire nuts.
Connect the yellow
wire from the
receiver to the black
wire from the fan.
Connect the blue wire
from the receiver to the
blue wire from the fan.
Remote
1886
Connect the three
grounding wires (green,
green/yellow stripe, or
bare copper) coming from
the ceiling, downrod, and
hanging bracket.
6
Troubleshooting