Suzuki FU150MF Owner's Manual page 113

Tai Nguyen; ; 06.02.2022 22:42.
To adjust the drive chain, follow these direc-
tions:
 CAUTION
A hot muffler can burn you. The muffler
will be hot enough to burn you for some
time after stopping the engine.
Wait until the muffler cools before
adjusting the drive chain.
1. Place the motorcycle on the center
stand.
2. Loosen the axle nut 1.
3. Adjust the drive chain slack by turning
the right and left chain adjuster nuts 2.
At the same time that the chain is being
adjusted, the rear sprocket must be kept
in perfect alignment with the front
sprocket. To assist you in performing this
procedure, there are reference marks 3
on the swingarm and each chain
adjuster which are to be aligned with
each other and to be used as a refer-
ence from one side to the other.
4. Tighten the axle nut 1 securely after
aligning and adjusting the slack in the
drive chain to 20 – 30 mm.
5. Tighten the chain adjuster nuts 2 lightly.
6. Recheck the chain slack after tightening
and readjust if necessary.
Rear axle tightening torque:
54 N·m (5.4 kgf-m)
6-41