NOTES
• Place the handset in the charger will
bypass the set date and time, and
voice guide.
• For best performance, keep the
handset in the charger when not in
use.
• The battery is fully charged after 16
hours of continuous charging.
• If you place the handset in the charger
without plugging in the battery, the
screen displays NO BATTERY.
Check the battery level
After you have installed the battery,
check the battery level on the handset
screen.
• If the battery icon is ,
go to
Set the date and time
the answering system through voice
guide.
• If the screen is blank, or flashes, then
the battery needs to be charged. Go
to
Charge the battery
any setting or operation.
Check for dial tone
HOME/FLASH. If you can hear
Press
a dial tone, the installation is successful.
If you do not hear a dial tone
• Make sure the installation procedures
described above are properly done.
• It may be a wiring problem. If you
have
changed
service to digital service from a cable
company or a VoIP service provider,
the telephone line may need to
be rewired to allow all existing
telephone jacks to work. Contact
your cable/VoIP service provider for
more information.
19
or , then
and
Set
before you do
your
telephone