Toyotomi CTN/CTG-328W User Manual page 15

buttons
Press « + » or « - » button once increase or decrease set temperature 1℃(℉).
Holding « + » or « - » button, 2s later, set temperature on remote controller
will change quickly. On releasing button after setting is fi nished, temperature
indicator on indoor unit will change accordingly.
The temperature cannot be adjusted in AUTO mode.
UD-swing button
Press this button can select up & down swing angle. Fan blow angle can be
selected circularly as below:
When selecting «
louver will automatically swing up & down at maximum angle.
When selecting «
position. Horizontal louver will stop at the fi xed position.
Hold « » button above 2s to set your required swing angle. When reaching
your required angle, release the button.
NOTE
Press this button continuously more than 2s, the main unit will swing back and
forth from up to down, and then loosen the button, the unit will stop swinging
and present position of guide louver will be kept immediately.
Under swing up and down mode, when the status is switched from off to
« » , if press this button again 2s later, «
directly; if press this button again within 2s, the change of swing status will also
depend on the circulation sequence stated above.
Humidity button
Under "Cooling mode":
(blink 5s)
humidity control
with cooling mode
By pressing the «Humidity Control» button «
unit will enter into «Manual Dehumidifi cation» mode. Both humidity (40~80%)
and temperature can be adjusted independently. (Setting method: increase
no display
(horizontal louvers stops
at current position)
», air conditioner is blowing fan automatically. Horizontal
», air conditioner is blowing fan at fi xed
smart dehumidifi cation
with cooling mode
15
» status will switch to off status
general
cooling mode
» on remote controller once, the
GB