Switching On/Off The Unit; Faceplate Release; Sound Adjustment; Loudness - Pyle PLCD85XMP Owner's Manual

OPERATION

SWITCHING ON/OFF THE UNIT

Switch on the unit by pressing any button
(except OPEN button (7) and
(4)). When system is on, press POWER
button (9) to turn off the unit.

FACEPLATE RELEASE

Press OPEN button (7) to detach the
removable faceplate.

SOUND ADJUSTMENT

Press SEL button (10) shortly to select
the desired adjustment mode.
The adjustment mode will change in the
following order:
VOL BAS
(Volume) (Bass)
By rotating the AUDIO knob (11)
clockwise or counter-clockwise, it is
possible to adjust the desired sound
quality.
Press and hold the SEL button (10) for
several seconds to enter into the
selection for the situation of beep sound,
then rotate the AUDIO knob (11)
clockwise or counter-clockwise to select
as follows:
BEEP 2ND BEEP ALL
- BEEP 2ND mode:
The beep is only generated when all
allowed double function button is
pressed long (several seconds).
e.g.
When preset button is pressed.
When BND/LOU button (13) is
pressed.
When PS/AS/D-AUD button (18) is
pressed.
- BEEP ALL mode:
The beep is generated when every
button is pressed.
- BEEP OFF mode:
The beep is disabled.

LOUDNESS

Press BND/LOU button (13) for several
seconds to reinforce the bass output.
Press it for several seconds again to
release this function.

SET THE CLOCK

Press the DSP button (15), the clock is
shown on the LCD display. Then hold
down the button until the clock flashes.
button
TRE BAL
(Treble) (Balance)
BEEP OFF
Then press the
hours or
minutes.

MUTE

Press MUT button (3) to mute down the
sound instantly. If any button is pressed
in the mute state, the mute state is
released.

EQUALIZATION

Press EQ button (19) to turn on
equalization function and to select
desired audio mode. There are five kinds
of mode as below:
FAD
FLAT
(Fader)

SUBWOOFER

Press MOD button (6) for several
seconds to toggle sub-woofer output.
Press it for several seconds again to
release this mode.

LIQUID CRYSTAL DISPLAY

Exhibit current frequency and activated
functions on the display (8).

REMOTE SENSOR

Point the remote control handset to the
remote sensor IR (24). Press the function
keys on the handset to control the
system.

RESET FUNCTION

RESET button (12) must be activated
with either a ballpoint pen or thin metal
object and it should be pressed for more
than one second.
The RESET button is to be activated for
the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: If press RESET button (12) for
more than one second, the unit can't
work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the
socket on the back of the front panel.

RADIO OPERATION

• SWITCHING TO RADIO MODE
Press MOD button (6) shortly to
select radio mode, the radio mode
appears in the display together with
the memory band and frequency.
9
button (17) to change
button (16) to change
CLASSICS POP M ROCK M DSP OFF