OPERATION
SWITCHING ON/OFF THE UNIT
Press PWR button (2) to turn on/off the
unit.
FACEPLATE RELEASE
Press release button
removable faceplate.
SOUND ADJUSTMENT
Press SEL button (5) shortly to select the
desired adjustment mode. The adjustment
mode will change in the following order:
BAS‐TRE‐BAL‐FAD‐LOUD‐EQ‐DX‐ST‐VOL
→
BAS: bass
TRE: treble
BAL: balance
FAD: fader
loudness
LOUD:
EQ: equalization
DX: distance
ST:
STEREO
VOL: volume
By rotating the audio knob (5) clockwise or
counter-clockwise, it is possible to adjust the
desired sound quality.
LOUDNESS
Long press the BAND button to active the
LOUD function. Press it and hold again to
cancel this function.
MUTE
Press MUTE button (24) to mute down the
sound instantly. If any button is pressed in
the mute state, the mute state is released.
LOCAL
Press LOC button (7) to select between
local and distant stations.
Local setting for reception of strong station,
and a distant setting for reception of
weaker stations. This function is effect
during SEEK operation.
MONO
Press MON button (21) to select mono or
stereo mode. You can sometimes improve
reception of distant stations by selection
(1) to detach the
9
EQUALIZATION
Press EQ button (22) shortly to turn on
equalization function and to select desired
audio mode. There are five kinds of mode
as below:
→FLAT→POP M→ROCK→CLAS→EQ OFF
DISPLAY INFORMATION
Press DISP button (9) to show the time
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display .
.
RESET FUNCTION
RESET button (8) must be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for the
following reasons:
-
Initial installation of the unit when all
wiring is completed.
-
All the function buttons do not operate.
-
Error symbol on the display.
Note: if press RESET button (8), the unit
can't work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the
socket on the front panel.
As photos :
RADIO OPERATION
SWITCHING TO RADIO MODE
Press MODE button (4) to select radio