Table of Contents
Advertisement
APPLICATIONS
Before using any chemicals
WARNING
and/ or solutions, read and
follow all original manufacturer instructions.
Read all Safety Data Sheets (SDS) and
container labels provided with the chemical.
Chemicals can cause serious bodily injury,
property damage, and/or damage the tool.
Wear personal protective equipment (PPE)
according to the chemical manufacturer's
instructions. Always wear eye protection.
(Cat. No. 491628PSA)
1. Fill the tank and then install onto the base.
2.
Put on the backpack and properly adjust the
straps.
3.
Slide the pack into the body of the tool to insert
the battery. Make sure it latches securely into
place.
4. Turn on the tool.
Pull the trigger and begin sweeping the nozzle
5.
from side to side, coating the desired surface
evenly
in
accordance
manufacturer's instructions.
6. If desired, lock-on the trigger for extended use.
7.
When done, release the trigger, turn off the tool,
remove the backpack, remove the battery, drain,
and clean the tank.
Supplying Water
(Cat. No. 491628WSA)
1. Fill the tank with clean water and then install
onto the base.
Slide the pack into the body of the tool to insert
2.
the battery. Make sure it latches securely into
place.
Place tool near the job within range of water
3.
supply hose.
Attach water supply hose with the quick connect
4.
fitting. Pull on the connection to be certain it is
properly secured.
5. To start water flow, turn on the tool.
6.
Monitor water level in tank. When empty, turn off
tool, disconnect the hose, and refill tank. Don't
run tool when tank is empty.
When done, turn off the tool, remove battery,
7.
disconnect hose, drain, and clean the tank.
Spraying
with
WARNING
angle the wand and hose downward and avoid
direct contact with skin.
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage
of parts, or any other condition that may affect the
tool operation. Return the tool, battery pack, and
charger to a MILWAUKEE
repair. After six months to one year, depending on
use, return the tool, battery pack and charger to a
MILWAUKEE
If the tool does not start or operate at full power
with a fully charged battery pack, clean the
contacts on the battery pack. If the tool still does
not work properly, return the tool, charger and
battery pack, to a MILWAUKEE
repairs.
chemical
WARNING
immerse your tool, battery pack or charger in
liquid or allow a liquid to flow inside them. Do
not use bleach as a cleaning agent.
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain
cleaning agents and solvents are harmful to
plastics and other insulated parts. Some of these
include gasoline, turpentine, lacquer thinner, paint
thinner, chlorinated cleaning solvents, ammonia
and household detergents containing ammonia.
Never use flammable or combustible solvents
around tools.
Keep electrical contact posts between bottom of
tank and base clean.
WARNING
contacts. Clean contacts with a dry, clean cloth
only.
WARNING
protective equipment (PPE) according to the
chemical manufacturer's instructions. Always
wear eye protection.
6
MAINTENANCE
Keep wand and hose pointed
away from people, always
Maintaining Tool
®
service facility for inspection.
®
To reduce the risk of personal
injury
and
Cleaning
Cleaning Electrical Contacts
Remove battery pack from tool
before
cleaning
Tank
Contacts
To
reduce the risk of injury ,
always
service facility for
service facility for
®
damage,
never
electrical
Base
wear
personal
Advertisement
Table of Contents
