Troubleshooting; Cleaning The Tank; Maintenance - Milwaukee M18 BPFP-CST User Manual

TROUBLESHOOTING

Problem Possible cause
Low pressure Not enough
battery charge
No pressure Not enough
battery charge
Leaky Connections are
not connected
properly; porous
gaskets
Motor is not The battery
running is empty or
defective.
No spray Spray nozzles are
blocked.
BLOCKED NOZZLES
1. Immediately turn off the sprayer. Ensure that the battery
door is closed securely.
2. Wear protective clothing, such as gloves and eye
protection.
3. Disassemble the nozzles and clean it with clear water.
4. Replace defective filters.

CLEANING THE TANK

1. Ensure that the battery door is closed securely.
2. Remove the tank from the base and set it on a level surface
away from the base to prevent exposing the base to harsh
chemicals.
3. Remove the tank cup and fill it up to about one-third full with
clean water. A small amount of mild household detergent
may be added. If needed, warm water (maximum of 50°C)
can be used. Replace the cap, and gently slosh the water
around the tank.
4. Install the tank, and spray the water until the tank is
emptied. Make sure to direct the spray towards an area
that will not be damaged by residue chemicals.
5. Repeat the procedure with clean water until the tank is
thoroughly clean. Wash the outside of the nozzles, and
wipe them dry with a cloth.
6. Wipe the outside of the tank with a clean, dry cloth.
7. Allow all pieces of the product to completely dry before
reinstalling the parts and storing the unit. Always reinsert
the strainer before replacing the tank cap.

MAINTENANCE

Servicing requires extreme care and knowledge, and should
be performed only by a qualifi ed service technician. Have the
product serviced by an authorised service centre only. When
servicing, use only original replacement parts.
Only make adjustments or repairs that are described in the
manual. For other repairs, contact an authorised service
centre.
Clean the product after each use.
Drain and empty the spray tank before cleaning.
Drain the spray materials through the fi ll area.
Solution
Drain all of the spray materials from the spray tank into a
container approved for chemicals. Do not store chemicals in
Charge the
the spray tank.
battery pack.
Use clean water to clean and rinse the spray tank. A small
Charge the
amount of mild household detergent may be added.
battery pack.
Wipe the product with a clean, dry cloth.
Retighten the
It may be necessary to rinse the spray tank more than once.
connecting
Cleaning electrical contacts
elements and
replace the
Keep electrical contact posts between the bottom of tank and
sealing elements.
base clean.
Recharge or WARNING! Remove the battery pack from the product before
replace the
cleaning electrical contacts. Clean the contacts only with a
battery pack. clean, dry cloth.
Clean the product
with compressed
air or a suitable
solvent.
Disposal
Never dispose of residual chemicals or contaminated rinsing
solutions in waterways, drains, sewers, street gutters, or
manholes.
Dispose of residual chemicals and used containers in
accordance with local waste disposal regulations.
ACCESSORIES
Use only MILWAUKEE accessories and spare parts. Should
components that have not been described need to be replaced,
contact one of our MILWAUKEE service agents (see our list of
service addresses).
If needed, an exploded view of the product can be ordered.
State the product type and the serial number on the label, and
order the drawing at your local service centres.
SYMBOLS
43
Tank Contacts
CAUTION! WARNING! DANGER!
Read the instructions carefully before
starting the product.
Remove the battery pack before starting
any work on the product.
English
Base
43