Table of Contents
Advertisement
Loom access point
Remove plastic knockout from the backing plate.
Create a hole in the wall to access the wall cavity
for routing the loom from the indoor unit to the
controller.
Put on a flat surface. Be careful not to distort the
back plate by over tightening the mounting screws.
Battery installation (CR2032)
Keep batteries out of reach of children.
Swallowing may lead to serious injury
WARNING
in as little as two hours, or death due to
chemical burns and potential perforation of
the oesophagus.
Slide the battery into the holder with the positive side facing up.
When first turning on set up the time of day. If the system is exposed
to a power outage the battery will maintain the time of day. If the
displayed time is not correct once power is restored try replacing the
battery.
6 |
Remove
knockout
Advertisement
Table of Contents
