Table of Contents
Advertisement
B.
Set top (long) trim panel in place on top of unit. The panel should be flat against outside face
of fireplace and standing vertically. Mark along lower edge of trim panel with a pencil to
make reference line for mounting.
(4) Slide the unit out of fireplace far enough to work behind trim panel reference lines with a
screw gun.
NOTE: You need to make sure supply gas line is hooked up at this time. Be sure to
check for leaks at connection using soap and water. DO NOT USE OPEN FLAME
TEST FOR LEAKS.
(5) With screws provided with fireplace kit, attach both side trim panels. Next, attach top trim
panels.
(6) Slide heater back into fireplace with trim panels flat against face of fireplace.
(7) After hooking up gas line, checking for leaks, and mounting trim panels slide heater into
fireplace.
(8) Place logs on burner base as shown on page 6. or 7.
(9) For gas hook-up and pressure tap test, see instruction in Section II.
WARNING: Solid-Fuels shall not be burned in a fireplace in which an unvented room heater is
installed.
CAUTION: Any outside air ducts and/or ash dumps in fireplace shall be permanently closed at time
of appliance installation.
WARNING: Before installing in a solid-fuel burning fireplace, chimney flue and firebox must be
cleaned of soot, creosote, ashes and loose paint by a qualified chimney cleaner.
Page 21
Advertisement
Table of Contents
