Responder Alert Sensors; Holster Sensor - Motorola APX 6000 User Manual

Procedure:
1 Turn on the handheld and activate the Bluetooth feature.
2 Place the handheld close to the radio aligning the Bluetooth Pairing Location on the handheld
with the Bluetooth Pairing Location on the radio.
If the pairing process is successful, you hear an incremental-pitched tone from the radio. The
radio begins to connect to the handheld. If the connecting process is successful, you hear an
incremental-pitched tone. The display shows <Device Friendly Name> connected, and
the Bluetooth icon turns from
If unsuccessful, one of the following scenarios occur:
• You hear a short, low-pitched tone and the display shows Bluetooth pairing failed (if
pairing fails).
• You hear a decremental-pitched tone and the display shows <Device Friendly Name>
unpaired (if the connection fails within 6 seconds).
• You hear a short, low-pitched tone and the display shows <Device Friendly Name>
connect failed (if the radio has the pairing record of the handheld and the connection
fails).
Repeat this step to re-initiate the pairing process.
NOTE: To unpair the handheld after a successful connection, follow the steps in
and Clearing the Bluetooth Device Information on page
7.26.6

Responder Alert Sensors

Responder alert sensors allow the radio to send an over-the-air (OTA) notification when the radio
receives the holster, weapon fired, and vest pierced sensor events.
To enable the feature, ensure that the GPS, Enhanced Data, and Bluetooth feature of your radio is
turned on and the radio supports Bluetooth Low Energy (BTLE).
You can disable the feature temporarily or permanently. This feature allows you to prevent one or all
events from being reported OTA.
This feature is enabled through Customer Programming Software (CPS) configuration. For more
information, contact your system administrator.
NOTE: The radio reports the next event after the programmed 15-second timer expires. Any
consecutive event occurring within the timer is not reported to avoid multiple reports over the
same incident.
7.26.6.1

Holster Sensor

Holster sensor monitors the state of the holster and allows the radio to send an Over-The-Air (OTA)
notification whenever a gun or a taser is pulled out of the holster or put in the holster.
The sensor can cache events that happen when the sensor is disconnected from the radio. When the
sensor is reconnected, the radio evaluates and sends the important events OTA to the system. For
more information, contact your system administrator.
If the sensor is disconnected from the radio for more than 30 minutes or if disabled, the holster sensor
clears the cached events.
to .
68012001079-JW
Chapter 7 : Advanced Features
117.
Viewing
119