Table of Contents
Advertisement
Loading Boot ROM software
Figure 5-7 Local loading using FTP
Console port
PC
Step 1: As shown in
connect the switch through the console port to the configuration PC.
You can use one computer as both configuration device and FTP server.
Step 2: Run the FTP server program on the FTP server, configure an FTP user name and password,
and specify the path of the program to be downloaded.
Step 3: Run the terminal emulation program on the configuration PC. Start the switch. Then enter the
Boot Menu.
At the prompt "Enter your choice (0-9):" in the Boot Menu, press <6> or <Ctrl+U>, and then press
<Enter> to enter the BootROM update menu shown below:
Bootrom update menu:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
Step 4: Enter 2 in the above menu to download the Boot ROM software using FTP. Then set the
following FTP-related parameters as required:
Load File name
Switch IP address
Server IP address
FTP User Name
FTP User Password
Step 5: Press <Enter>. The system displays the following information:
Are you sure to update your bootrom?Yes or No(Y/N)
Step 6: Enter Y to start file downloading or N to return to the BootROM update menu. If you enter Y, the
system begins to download and update the program. Upon completion, the system displays the
following information:
Loading........................................done
Bootrom updating..........done!
Switch
Ethernet port
FTP Client
Figure
5-7, connect the switch through an Ethernet port to the FTP server, and
:S3100-SI.btm
:10.1.1.2
: 10.1.1.1
:3100-SI
:abc
FTP Server
5-9
Advertisement
Table of Contents
