Table of Contents
Advertisement
Installation procedure
Follow these steps to complete magnet mounting:
1)
As shown in
Figure
the round hole at the center of the permanent magnet, fasten it to a blind nut in the dent of the
switch bottom, and ensure that the permanent magnet and the switch are fastened reliably.
Remove the cushion, if any, from the dent before installation.
To ensure the firmness of installation, be sure to use four permanent magnets to secure each
S3100 switch.
2)
Attach the magnet-mounted device to the specified location. Take care not to get your fingers stuck
between because the magnetism is very huge.
Figure 3-18 Magnet mounting
(1) Blind nut in the dent of the switch bottom
(3) M3*6 countersunk head screw
3-18, use a Phillips screwdriver to pass the countersunk head screw through
(3)
(2)
3-13
(1)
(2) Permanent magnet
Advertisement
Table of Contents
