Setting The Time Of Day; Setting The Water Hardness Level - Miele PFD 100 SmartBiz Operating Instructions Manual

Setting the time of day

The time of day is set automatically if
a connection is established with the
WiFi network.
The display will then change to the
screen for setting the time of day.
The current time of day must be set
before you can use the timer option.
 Use the  sensor controls to enter
the hour and confirm your entry by
touching OK.
 Then set the minutes and confirm
with OK.
Holding down the relevant  or
 sensor control will increase or
decrease the time automatically.
Before using for the first time

Setting the water hardness level

The display will change to the screen
for setting the water hardness.
- You should programme the
dishwasher to the correct water
hardness for your area.
- Your local water authority will be able
to advise you of the water hardness
level in your area.
- Where the water hardness fluctuates
e.g. between 1.8 and 2.7 mmol/l (10 -
15 °dH - German scale) always
programme the dishwasher to the
higher value (2.7 mmol/l or 15 °dH in
this example).
In the event of a fault, it will help the
service technician if you know the
hardness of your local water supply.
Therefore, please enter the water
hardness:
____________°dH or mmol/l
The dishwasher is programmed at the
factory for a water hardness level of
2.5 mmol/l (14 °dH – German scale).
 Set the water hardness level in your
area and confirm using OK.
See the "Settings" chapter, "Water
hardness" section for more
information.
21