Table of Contents
Advertisement
4. All components and the container are dishwasher safe, plac-
groove
ing them in the top basket. If you do not have a dishwasher,
hollow
wash by hand as described in the note at the end of the
section.
Make sure there are no milk residues on the hollow and
groove under the dial (fig. 30). If necessary, scrape the
groove with a toothpick.
30
5. Rinse inside the froth adjustment dial seat with running
water (fig. 31).
6. Check that the intake tube and spout are not clogged with
milk residues.
7. Replace the dial (in correspondence to the word "INSERT"),
spout and milk intake tube.
8. Place the lid back on the milk container.
Please note: washing by hand
Washing in a dishwasher guarantees the perfect hygiene of all
the milk container components. When washing by hand, wash
all components of the milk container thoroughly withhot water
and immerse them in a basin of hot water for 30 minutes before
proceeding as described in point 5.
11.11 Cleaning the hot water nozzle
Every now and then, clean the connection nozzle (A10) with a
sponge to remove milk residues from the gaskets (fig. 18).
18
29
31
12. DESCALE
Important!
•
Before use, read the instructions and the labelling on the
descaler pack.
•
It is important to use De'Longhi descaler only. Using un-
suitable descaler and/or performing descaling incorrectly
may result in faults not covered by the manufacturer's
guarantee.
•
Descaler could damage delicate surfaces. If the product is
accidentally spilt, dry immediately.
To descale
Descaler
De'Longhi descaler
Container
Recommended capacity: 2 l
Time
~45min
Descale the machine when the corresponding message appears
on the display (D5). To descale immediately, press
and follow the instructions from point 6. To descale later, press
. (B2): on the display the
pliance needs descaling.
To access the descaling menu:
1. Turn the appliance on and wait until it is ready for use;
2. Press
to enter the "Settings" menu;
3. Press the scroll arrows
"Maintenance" is displayed, then press
4. Press the scroll arrows
displayed, then press
5. Confirm by pressing
6. (If the filter is installed): extract the water tank (A14), re-
move the water softener filter (C4) and empty the water
tank. Press
;
7. Pour the descaler into the tank up to level A (corresponding
to a 100ml pack) marked on the inner surface of the tank,
then add water (one litre) up to level B (fig. 32) and put the
water tank back. Press
8. Remove, empty and replace the drip tray (A19) and
grounds container (A17). Press
+
A
B
A
15
symbol reminds you the ap-
(B3) or
(B10) until
;
or
until "Descaling" is
;
;
;
;
B
2l
32
(B11)
33
Advertisement
Table of Contents
Troubleshooting
