Table of Contents
Advertisement
Attach the air release cap to the
17
end of the hose.
If the air release cap is not
attached, the sealant may leak
and the vehicle may get dirty.
Temporarily store the bottle in the luggage compartment while it is
18
connected to the compressor.
To spread the liquid sealant evenly within the tire, immediately drive
19
safely for about 3 miles (5 km) below 50 mph (80 km/h).
After driving, stop your vehicle
20
in a safe place on a hard, flat
surface
repair kit.
Remove the air release cap from
the hose before reconnecting the
hose.
Turn the compressor switch on and wait for several seconds, then
21
turn it off. Check the tire inflation pressure.
If the tire inflation pressure is
1
under
1.3 kgf/cm
puncture cannot be repaired.
Contact your Toyota dealer.
If the tire inflation pressure is
2
19 psi (130 kPa, 1.3 kgf/cm
or bar) or higher, but less
than the specified air pres-
sure: Proceed to step
If the tire inflation pressure is the specified air pressure (P. 658):
3
Proceed to step
PRIUS_OM_OM47E01U_(U)
7-2. Steps to take in an emergency
and
reconnect
the
19 psi
(130 kPa,
2
or
bar): The
.
22
.
23
2
609
7
Advertisement
Table of Contents
