Toyota HIGHLANDER HYBRID 2007 Manual page 296

Table of Contents

Advertisement

3. Simultaneously
press
and
hold
hand−held
garage
transmitter
along with the selected HomeLink
ton.
Do not release the buttons until step 4
has been completed.
4. When
the
indicator
light
R
HomeLink
changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
284
the
5. Test the operation of the HomeLink
button
pressing the newly programmed button.
R
but-
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
on
the
"Rolling Code" type. Press and hold the
programmed HomeLink
rage door has the rolling code feature if
the indicator light (on the HomeLink
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the "Rolling Code" type, proceed to the
heading "Programming a rolling code sys-
tem".
'07 HIGHLANDER HV_U (L/O 0608)
6. Repeat steps 2 through 5 for each re-
maining HomeLink
another device.
Programming a rolling code system
If
your
equipped,
steps 1 through 4 under the heading
"Programming the HomeLink
proceeding with the steps listed below.
1. Locate the "training" button on the ceil-
ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
door
opener.
R
by
guide supplied by the garage door
opener manufacturer for the location of
this "training" button.
2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 seconds
in which to initiate step 3 below.
R
button. The ga-
3. Press and release the vehicle's pro-
grammed HomeLink
R
)
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
complete the programming process by
opening the garage door.
2007 HIGHLANDER HV from July '06 Prod. (OM48685U)
R
button to program
device
is
"Rolling
Code"
it
is necessary
to
follow
R
" before
Refer
to
the owner's
R
button twice. The

Advertisement

Table of Contents
loading

Table of Contents