Olivetti PGL2540 Operation Manual page 187

Troubleshooting > Troubleshooting
Message
Cannot connect server
Press Go
Cannot connect to
Authentication Server
Cannot connect.
Cannot read data in this
ID Card.
Cannot recognize.
Cannot start this job
Press Go
Cannot use this
function.
Close front cover.
Connection limit
exceeded.
D
Message
Device busy
Duplex disabled
Press GO
Checkpoints
―
―
―
―
―
―
―
―
Is there any cover which is open?
―
Checkpoints
―
Did you select a paper size/type
that cannot be duplex printed?
8-17
Corrective Actions
The job is canceled. Select [Go] key.
Check the connection status with
the server.
Set machine time to match the
server's time.
Check the connection status with
the server.
This appears when the Wi-Fi or Wi-
Fi Direct connection did not
complete. Check the settings, and
check the signal conditions.
In registration process, the ID card
information was not read correctly.
Hold again the ID card over the ID
card reading part.
If the same message still appears,
the ID card may not be compatible
with this product. Change it to
another ID card.
Make sure your ID card has been
registered.
You cannot use the specified box.
Job is canceled. Select the [GO]
key.
This message is displayed when a
user tries to use the restricted
function.
Close the cover indicated on the
screen.
Cancel a connection to a portable
device that is not being used, or set
the machine's auto disconnect time
to break portable device
connections.
Corrective Actions
This message is displayed when
Remove Device was selected while
a USB memory was being used.
The previous screen is displayed
again 1 or 2 seconds.
Select [Menu] to select the
available paper. Select the [GO] key
to print without using Duplex
function.
Reference
Page
―
page 2-15
―
page 6-10
―
―
―
―
―
―
Reference
Page
―
―