Table of Contents
Advertisement
The charge light is off.
•
Make sure the power cord is plugged in correctly and securely.
•
Make sure the battery is installed correctly in the handset. Follow the instruction in
Battery installation on pages 4-5 to install the battery.
•
Unplug the electrical power. Wait for 15 seconds, then plug it back in. Allow up to
one minute for the cordless handset and telephone base to reset.
•
Clean the cordless handset and telephone base charging contacts each month
using a pencil eraser or cloth.
I get noise, static, or weak signals even when I'm near the telephone base.
•
If you subscribe to high-speed Internet service (DSL - digital subscriber line)
through your telephone line, you must install a DSL filter between the telephone
line cord and the telephone wall jack (see Installation on page 2). The filter
prevents noise and caller ID problems caused by DSL interference. Please contact
your DSL service provider for more information about DSL filters.
•
Other electronic products such as HAM radios and other DECT phones, can cause
interference to your cordless telephone. Try installing your telephone as far away
as possible from these types of electronic devices.
•
Do not install this telephone near a microwave oven or on the same electrical outlet.
You may experience decreased performance while the microwave oven is operating.
•
If your telephone is plugged in with a modem or a surge protector, plug the
telephone (or modem/surge protector) into a different location. If this doesn't
solve the problem, relocate your telephone or modem farther apart from one
another, or use a different surge protector.
•
Relocate your telephone to a higher location. The telephone will likely have better
reception when installed in a high area.
•
If the other telephones in your home are having the same problem, the problem
is in your wiring or telephone service. Contact your telephone service provider
(charges may apply).
I experience poor sound quality when using the speakerphone.
•
For increased sound quality while using the speakerphone, place the handset on a
flat surface with the dial pad facing up.
•
When using a speakerphone, controlling background noise in your environment is
essential. While you are listening to your party, press MUTE/
turn your microphone off. When it is your turn to speak, remember to press
MUTE/
DELETE
•
Excessive background noise will cause a speakerphone to fade in and out. Try
controlling the background noise by turning off any audio devices near the
speakerphone. Also, try to avoid interrupting the person at the other end of the
conversation while they are speaking. If background noise cannot be controlled,
you should terminate speakerphone operation and return to normal handset
mode.
again to turn the microphone on.
31
to temporarily
DELETE
Advertisement
Table of Contents
