Table of Contents
Advertisement
HOW TO ADJUST THE GAUGE WHEELS
The axle bolts for the gauge wheels were mounted in the LOW cut
position. To change the position of the gauge wheels, move the axle
bolts as follows.
IMPORTANT: Before you adjust the gauge wheels, you must do
the following. Make sure the mower housing is level. Make sure
the height of cut is set at the height you want for your lawn.
Mow a short distance on a flat level area and look at the area
that was cut. If the mower housing does not cut level, see the
instructions "How To Level The Mower Housing."
WARNING: Before you make an inspection, adjust-
ment, or repair to the unit, disconnect the wire to the
spark plug. Remove the spark plug wire to prevent
the engine from starting by accident.
1.
Remove the gauge wheels (Figure 26).
2.
Mow a short distance on a flat level area to check the level of
cut and the height of cut. Look at the height of cut position
number on the lift lever (Figure 27).
3.
Look at each gauge wheel bracket. There are 3 holes in each
bracket and a number next to each hole. The number for the
height of cut position on the lift lever indicates the correct hole
to use on each gauge wheel bracket (Figure 28).
4.
Assemble the axle bolts to the gauge wheel brackets using
the correct hole in the bracket as indicated (Figure 28).
NOTE: If the height of cut position is changed by the lift lever,
you must move the gauge wheels to the correct hole
(Figure 28) to keep a level height of cut.
F–040741L
MAINTENANCE
Locking
Ring
Gauge
Wheel Bracket
28
Axle Bolt
Washer
Lift Lever
Wheel Bracket
Hole No.
1
2
3
Gauge Wheel
Figure 26
Cutting Height Positions
Figure 27
Lift Lever
Position No.
1
2
3,4,5,6
Figure 28
Advertisement
Table of Contents
