Ariens ST11528DLE Owner's/Operator's Manual page 28

OS7180
Speed Selector Adjustment
To adjust (Figure 31):
1. Disconnect adjustment pivot pin from
speed selector lever by removing hair
pin.
2. Place the speed selector in the fastest
forward speed position.
3. Turn the speed selector lever straight
down towards the ground as far as it will
go.
4. Thread the adjustment pivot pin along
the shift rod until it aligns with the mating
hole on the speed selector lever. Insert
the pivot pin into hole.
5. Secure adjustment pivot pin with hairpin.
6. Make sure the speed selector shifts into
each speed position.
Loosen upper
adjustment nut.
Tighten lower
adjustment nut.
Figure 30
1
4
3
1. Shift Rod
2. Adjustment Pivot Pin
3. Speed Selector Lever
4. Hairpin
Attachment Clutch/Brake
Adjustment
(Figures 32, 33 and 34)
IMPORTANT: IMPROPER
ADJUSTMENT could result in
unexpected movement of auger
and impeller causing death or
serious injury. Auger / impeller
must stop within 5 seconds when
Attachment Clutch/Impeller Brake
lever is released.
Remove Attachment Cable Slack
1. Remove the belt cover.
2. Loosen jam nut on cable adjustment
barrel, and then turn the adjustment
barrel up or down to lengthen or shorten
cable and remove all cable slack. See
Figure 32.
GB - 28
Figure 31
2
OS7185