Service And Adjustments; Service Position; Adjust Handlebar Height - Ariens Razor 911173 Operator's Manual

Hide thumbs Also See for Razor 911173:

Owner's/operator's manual (62 pages)

Operator's manual (32 pages)

Table Of Contents

Table of Contents

CAUTION: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

SERVICE POSITION

Put unit into service position for easy access

to bottom of deck.

CAUTION: Avoid fuel spills. Follow

steps below to help prevent fuel

spills. If fuel leaks into air cleaner,

replace air cleaner. ALWAYS clean

up any spilled fuel.

1. Place unit on a flat, level surface.

2. Disconnect spark plug wire.

3. Remove fuel cap.

4. Place a piece of plastic bag over the

opening and tighten cap securely.

5. Remove discharge chute, if installed.

6. Tip unit onto right side. Make sure unit is

secure and will not tip over.

IMPORTANT: Remove plastic from fuel cap

after unit is upright and service is complete.

ADJUST HANDLEBAR HEIGHT

Model 911173

To adjust handlebar height:

See Figure 16.

1. Remove hardware from lower handlebar

mounting holes.

2. Rotate handlebar to desired position.

3. Align mounting holes with holes in the

handlebar mount and secure handlebar

with hardware removed earlier.

To position handlebar for storage:

See Figure 18.

1. Remove hardware from lower handlebar

mounting holes.

2. Rotate handlebar forward.

3. Secure handlebar with hardware

removed earlier.