Adjusting Cutting Height - Ariens Razor 911173 Operator's Manual

4
1. Rear Door
2. Bagger
3. Bag Mount
4. Mulch Plug
Figure 10
Side Discharging Clippings
See Figure 11.
To install side discharge chute:
1. Shut off unit.
2. Remove grass bag.
3. Lift rear door and install mulch plug (see
Figure 10). Make sure mulch plug is
locked by pulling on the handle near the
bottom of the plug.
4. Open the side discharge.
5. Align side discharge chute onto the
mower tabs. Make sure chute covers
discharge opening.
6. Rest side discharge on chute to secure.
2
1
3
1
1. Side Discharge Chute
2. Side Discharge
3. Tabs
To remove side discharge chute:
1. Lift side discharge cover.
2. Lift side discharge chute off of tabs to
release from mower and remove chute.
Mulching Clippings
See Figure 10 and Figure 11.
1. Shut off unit.
2. Remove grass bag or side discharge
chute, if installed.
3. Make sure side discharge cover is
closed.
4. Lift rear door and insert mulch plug.
Make sure lock snaps in place.
There should be no openings between
mulch plug and mounting surface of the
deck.
5. Close rear door. Door must fit tightly
against frame.

ADJUSTING CUTTING HEIGHT

DANGER: Avoid injury from
rotating blade.
ALWAYS shut off engine before
adjusting cutting height.
To change cutting height, move cutting height
lever one notch at a time to set desired height
(Figure 12).
EN - 15
3
2
Figure 11