Operation; Cutting Height Adjustment - Ariens 911250 – Pro21 Owner's/Operator's Manual

CONTROLS AND FEATURES
See Figure 7 for locations.
WARNING: Improper operation
can lead to injury. Learn what the
controls do and how they work.
Thoroughly read and understand
entire Operator Manual.
CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Engine/Blade Control
CAUTION: Check function of
Engine/Blade Control regularly.
Improper function of control could
cause injury.
The engine/blade control must be held
against the handlebar to start the engine and
blade.
Engine/blade control feature on mower stops
engine and blade within 3 seconds whenever
operator releases handlebar. Check this
feature frequently. If feature fails to operate,
disconnect spark plug wire and adjust or have
it repaired before using unit.
START and RUN
Recoil Starter Handle
When pulled, the recoil starter handle will turn
engine over.

OPERATION

STOP

CUTTING HEIGHT ADJUSTMENT

DANGER: Avoid injury from
rotating blade.
ALWAYS shut off engine before
adjusting cutting height.
CAUTION: Both rear wheels must
be set at same height or traction
drive may not work properly.
CUTTING HEIGHT
SETTINGS CHART
1
1-1/4
1-1/2
1-3/4
2
2-1/4
2-1/2
2-3/4
3
3-1/4
3-1/2
3-3/4
4
P = Position of the Cutting Height Lever
H = Hole in the Front Axle Bracket
GB - 12
P1/H1
P2/H2
P3/H2
P3/H3
P4/H4 P1/H4
P5/H4 P2/H4
P5/H5 P2/H5
P6/H6 P3/H6
P4/H6
P4/H7
P4/H8
P5/H8
P6/H9