D-Link DWR-953 User Manual page 93

Section 3 - Configuration
If Ether Type is set to IP or IPv6:
Source IP/ Specify whether the class will be applied to the Source IP,
Vendor Class/ Vendor Class, or User Class from the drop-down manu, and
User Class:
then enter the corresponding value.
If Ether Type has been set to IPv6, enter the source IPv6 address.
(Optional)
Destination Specify a destination IP address to which the class will be
IP/IPv6 applied. (Optional)
Destination
IP:
Subnet Mask/ Enter an destination mask/subnet prefix length to which the rule
Subnet Prefix
will apply. (Optional)
Length:
Source MAC Specify a Differentiated Services Code Point (DSCP) for the
Address DSCP
source MAC address. (Optional)
Check:
Select a protocol from the list to classify. If you select TCP or
Protocol:
UDP, additional options will appear. (Optional)
If Ether Type is set to 8021Q:
802.1p
Enter the priority code point assigned to filtered frames. 1
Priority:
is lowest priority, 0 is default priority, and 2-7 are increasing
priority, with 7 being highest. (Optional)
Specify Classification Results:
Assign For packets that trigger this classification, specify in which queue
Classification
they should be placed. (Required)
Queue:
D-Link DWR-953 User Manual 88