D-Link DWR-953 User Manual page 73

Section 3 - Configuration
The rules page allows you to assign rules for specific protocols attached to existing filters.
Filter Name: Select the filter to which to apply the rule.
Enable: Check this box to enable the rule. This can be changed later.
Ether Type Select an EtherType from the dropdown menu to which the rule
will apply.
Port: Select a protocol from the dropdown menu to which the rule will
apply.
Action: Specify whether the incoming packet should be dropped,
permitted, rejected (return an error), logged and dropped, or
logged and permitted.
If ICMP has been selected for Port above and if Ether Type
ICMP Type:
has been set to IPv4 or IPv6, select an ICMP type from the
dropdown list. (Optional)
Origin IP/IPv6 If Ether Type has been set to IPv4 or IPv6, enter the origin IP
Address:
address to which the rule will be applied. (Optional)
Origin Mask/ If Ether Type has been set to IPv4 or IPv6, enter an origin mask/
Subnet Prefix
subnet prefix length to which the rule will apply. (Optional)
Length:
Origin Port: If Port has been set to TCP or UDP and Ether Type has been
set to IPv4 or IPv6, specify an origin port to which the rule will
apply. (Optional)
D-Link DWR-953 User Manual
Packet Filter -- Rules
68