Maytag MLG21PD Installation Instructions Manual page 11

Stacked Washer/Gas Dryer Electrical Requirements
IMPORTANT: Observe all governing codes and ordinances.
You will need an earthed electrical outlet located within 610 mm
(2 feet) of either side of the washer/dryer.
This washer/dryer is supplied/fitted with an electrical supply cord
and plug. It should be connected to electrical supply socket at
the voltage shown on the rating plate. The minimum supply fuse
capacity should be 10A. The washer/dryer must be positioned so
that the plug is clearly visible and accessible. This plug also provides
the function of an emergency stop control for the user. If the fitted
plug is not used, the electrical connection must be carried out by a
competent electrician in accordance with local or national codes.
If the supply cord is damaged, it must be replaced with a specially
terminated cord by an authorized service agent or a similarly
competent person in order to avoid a hazard.
Do not use an adapter.
Do not use an extension cord.
NOTE: In accordance with the European EMC Directive (2004/108/
EC), the maximum electricity supply system impedance to which
the gas dryer should be connected is declared to be 0.054 Ohm +
j0.034 Ohm.
NOTE: Electrical safety standards: The manufacturer has chosen
compliance with IEC/EN.60335 standards as the most appropriate
for this product.
If codes permit and an additional earth bond wire is used, it is
recommended that a qualified electrician determine that the earth
bond path is adequate.
STACKED WASHER/GAS DRYER INSTALLATION
EARTHING INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Using the universal cord included with this dryer:
The gas dryer is equipped with a universal cord with
interchangeable plugs.
1. To use the universal cord, select the plug end that fits your
electrical outlet, and plug it into the adapter on the supply cord.
2. Secure the plug end in place on the cord by aligning the 2 cover
halves over the cord adapter and clipping them together.
REQUIREMENTS
11