G
S
G
ETTING
TARTED
UIDE FOR THE
Setting and Using Camera Presets
10
VSX S
ERIES
To adjust the camera on the VSX 3000 system:
Focus the camera by turning the focus wheel:
Camera presets are stored camera positions that you can create ahead of time
or during a call.
Presets allow you to:
Automatically point a camera at pre-defined locations in a room.
Select a video source such as a VCR or DVD player, a document camera,
or an auxiliary camera.
If your system's main camera supports electronic pan, tilt, and zoom
movement, you can create up to 100 preset camera positions for the near site.
Each preset stores the camera number, its zoom level, and the direction it
points (if appropriate). Near-site presets are available for VSX set-top and
component systems. They remain in effect until you delete or change them.
Depending on configuration capabilities, you may be able to control the
camera at the far site. If far-site camera control is allowed, you can create up
to 16 presets for the far-site camera. These presets are saved only for the
duration of the call. You may also be able to use presets that were created at
the far site to control the far-site camera.
To move the camera to a preset:
1. If a call is connected, press
or far-site camera or other video source.
2. Press a number on the remote control.
The camera moves to the preset position for the camera or other video
source.
Near or
Far to choose a near-site
.
.
WWW
POLYCOM
COM
/
VIDEODOCUMENTATION