How To Diagnose Hdd Failure; Defective Hdd; Hdd Recognition Status - Sony RDR-HX950 Service Manual

4. HOW TO DIAGNOSE HDD FAILURE

4-1. Defective HDD

There are four symptoms of defects in the HDD.
1. "E01" is displayed on the FLD.
(The HDD is not recognized or is not authorized.)
2. "E02" is displayed on the FLD.
3. When playing a video, MP3, or JPG, contents freeze.
4. Irregular noises from the HDD

4-2. HDD Recognition status

How to enter Recognition status and sub screen mode.
• While the GUI screen is not displayed, use the service remote controller and press "ESC" key followed by "DISP" key.
• While the first screen is displayed, press "DIG/ANA" key repeatedly until the desired subscreen is displayed.
The subscreens change.
MRX-1635/EC1 VERSION : 1.01
SYSCON : RELEASE 104
Rev. 1. 5895
TUNERCON : 1.178
DRIVE : DVD-RW DVR-L12X
1.00
PIC SERIAL : 000800004940
HDD INT : WDC WD2500AAJS 9
DEVICE : E2R-FEx1.0
REGION : 2
FL Display OS Display
"Repaining the HDD".
r
REPAIR
"HDD repair is
complete".
An error occurred.
Please consult your
nearest Sony dealer.
E01 Note that contents on
the HDD may be
erased when servicing
this unit.
The Hard Disk Drive
info is incorrect.
E02
Use the Disk Setup
menu to reformat.
Normal
All manuals and user guides at all-guides.com
OK
OK
OK
• Details on HDD data are described below:
250
FLASH : 64M
C : 0000400259
HDCP : 0000400259
HDD identification
conditions
Failure to physically
identify the HDD (no
connection, defective
HDD, interface error).
Physical identification of
HDD possible, but not
identified
Physical identification of
HDD possible, HDD
identified, but failure in
logical formatting.
Physical identification of
HDD possible, HDD
identified, and correct
logical formatting (HDD
correctly identified).
— 7 —
Service remote controller
(Part code: J-6090-203-A)
HDD : WDC1023456 # 160
Details on HDD data
are described below.
Blank space
WDC 10234564 # 160
WDC 10234564 ! 160
WDC 10234564 160
Capacity of the HDD (unit: Gbytes)
HDD identification error indication
HDD model name
Remarks
Check the connection to the
SATA cable and power cable.
Replace the SATA cable or
power cable.
Replace the HDD.
Replace the FE or part in the
SATA/ATA communication.
"#" indicates that the HDD is
unauthorized.
"!" indicates an HDD
authorization error. Initialize
the HDD.