Table of Contents
Advertisement
ROUGH-IN PLUMBING
Turn off the main water supply.
Install or relocate the supplies and outlets as necessary
to conform to roughing-in dimensions. See Fig. #3 . For
supply stop location, See Fig. #4 .
CAUTION: Risk
back-to-back installations. See Fig. #2 . To
prevent possible trap seal loss, the back-to-back
Pressure Lite toilet should be connected to a vertical
stack using one of the following three fittings:
S
Double fixture fitting
S
Double combination wye and 1/8 bends
S
Double wye and 1/8 bends
ROUGHING-IN DIMENSIONS
1-1/8"
27-3/4"
3-7/16"
C L OF OUTLET
12"
INSTALL SUPPLY STOP
For supply installation, refer to the instructions packed
with the supply stop.
Locate the supply stop so it is 2-5/8" above the floor line,
and 7-3/4" to the left of the centerline of the closet flange.
Kohler Co., Kohler, WI
of
trap
seal
loss
1-7/8"
19-1/2"
14-7/8"
3/8" I.P.S. SUPPLY
Double
Fixture
in
Fitting
21-1/4"
2-5/8"
7-3/4"
Fig. #3
2-5/8"
3
Double
Double Wye
Combination
and 1/8
Wye and 1/8
Bends
Bends
Fig. #2
FRONT OF BOWL
10-1/2"
K-3404-FB BASE
Supply Stop
7-3/4"
12"
Fig. #4
113363-2-
13-1/4"
4-1/2"
EA
(9532)
Advertisement
Table of Contents
