Section 7 − Maintenance & Troubleshooting; Routine Maintenance; Blowing Out Inside Of Unit - Miller XMT 350 VS Auto-Line w/WCC Owner's Manual

SECTION 7 − MAINTENANCE & TROUBLESHOOTING

7-1. Routine Maintenance

7-2. Blowing Out Inside Of Unit

OM-252 340 Page 28
Replace
Damaged Or
Unreadable
Labels
!
Disconnect power
before maintaining.
3 Months
Repair Or
Replace
Cracked
Cables
6 Months
Blow Out Inside
.
Maintain more often
during severe conditions.
Replace Cracked
Torch Body
Repair Or Replace
Cracked Cables
And Cords
Clean
And
Tighten Weld
Connections
!
Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
803 728-B