Section 5 − Installation; Selecting A Location; Associating Wcc Wire Feeder To Wcc Power Source - Miller XMT 350 VS Auto-Line w/WCC Owner's Manual

5-1. Selecting a Location

!
Do not move or operate unit
where it could tip.
Location
18 in.
(460 mm)

5-2. Associating WCC Wire Feeder To WCC Power Source

Quick Setup Guide:
1 To associate the 350 VS w/WCC select any process except LIFT ARC TIG.
2 Pull trigger on gun.
3 Do not strike an arc.
4 Decimal points on feeder voltmeter will blink.
5 When decimal points stop blinking and a voltage is displayed on the feeder or when REMOTE IN USE light on Power Source front panel
becomes lit, the feeder and power source are associated.
6 Use voltage control on feeder to adjust weld voltage.
7 Voltmeter on feeder will alternate between preset voltage and open circuit voltage while idle. While welding the feeder will display the actual
weld voltage at the wire feeder.
.
See Section 5-3 for detailed equipment setup.
SECTION 5 − INSTALLATION
1
3
18 in.
(460 mm)
1
Movement
2
8 Lifting Handles
Use handles to lift unit.
9 Hand Cart
Use cart or similar device to move
unit.
10 Line Disconnect Device
Locate unit near correct input
power supply.
!
Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
loc_2 3/96 - Ref. ST-151 556 / Ref. 803 691-C
OM-252 340 Page 15