Burner Tubes - England's Stove Works 50-SNC32 Installation & Operation Manual

Burner tube replacement
There are five different burner tubes in the top of the stove. To replace a tube, first be sure
that you order the correct tube you need to replace. Then using a 5/16" socket or open end
wrench, remove the screw located on the left side of the tube. Be sure to keep the screw.
Push the tube to the right then remove the tube (pulling the tube back to the left after that
side has been removed from the hole). To replace, reverse the above procedure...make sure
to install the tubes in the correct order. (Front to Back)
Ceramic fiberboard replacement
There are four fiber boards located in the
top of this stove, in two layers. While the bottom
layer is oriented 'North/South' as shown, the top
layer is oriented 'East/West'. To replace a cracked
or broken board, first remove the front burner
tube. Then remove the board you need to
replace. Install the new board (two boards on
each layer should sit flush on the tubes side by
side). Replace the tube previously removed.
Page | 24
REPLACING COMPONENTS
Front (Door Side)
of Unit
30‐BT4
30‐BT4
30‐BT2
30‐BT2
30‐BT2
Rear of Unit
Fiber Boards (4 total)
Burner Tubes