Factory Default Settings - NETGEAR GSS116E User Manual

Factory Default Settings

You can return the switch to its factory settings. Use the end of a paper clip or some other
similar object to press and hold the Factory Defaults button on the back panel of the switch
for at least four seconds. The switch resets and returns to the factory settings that are shown
in the following table.
Table 3. Factory default settings
Setting
Switch name
Switch password
IP address
Subnet mask
DHCP mode
Port speed
Flow control
Loop detection
Port LED control
Power saving mode
(model GSS108EPP only)
Switch management mode
Access control
(model GSS108EPP only)
Port mirroring
IGMP snooping
PoE
LAGs
Supplemental Information
8-Port and 16-Port Gigabit Ethernet Plus Click Switch
Value or Description
None (empty)
password
192.168.0.239
255.255.255.0
Enabled
Auto negotiation
Disabled
Disabled
Link speed and activity
Enabled
Through a web browser by accessing the local browser interface or the
ProSAFE Plus Utility
Disabled
Disabled
• Enabled. IGMP snooping status
• Disabled. Validation of IGMPv3 IP headers
• Disabled. Blocking of unknown multicast addresses
• Port Power. Enabled
• Port priority. Low
• Power mode. 802.3at
• Power limit type. User
• Power limit. 30.0W
• Detection type. IEEE 802
Disabled
Note: LAGs are supported on switch models GSS108EPP and GSS116E,
but they are not supported on switch model GSS108E.
75 User Manual