Initial Operation - Metabo KHA 18 LTX BL 24 Quick Operating Instructions Manual

en ENGLISH
Only send the battery pack if the housing is intact
and no fluid is leaking. Remove the battery pack
from the machine for sending. Prevent the contacts
from short-circuiting (e.g. by protecting them with
adhesive tape).
Additional Warnings:
WARNING
drilling, and other construction activities
contains chemicals known to cause cancer,
birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemicallytreated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic
particles.
Symbols on the tool:
.......Class II Construction
V...........volts
A...........amperes
Hz.........hertz
W..........watts
BPM .....beat per minute
.......direct current
n .........no-load speed
0
rpm.......revolutions per minute
.../min ...revolutions per minute
4. Overview
See page 2.
1 Keyless chuck *
2 Keyless chuck sleeve *
3 Chuck lock
4 Tool lock
5 SDS chuck
6 Spindle
7 Additional handle
8 Depth stop
9 Metabo VibraTech (MVT)
10 Rotation selector switch
11 Trigger switch
12 Lock
13 Switch button (for changing the operating
mode)
14 Guide groove for the dust extraction
ISA 18 LTX
15 Battery pack release button
16 Rubber cover for dust protection of the power
supply for the dust extraction ISA 18 LTX
17 LED light to illuminate the workplace
18 Capacity indicator button
19 Capacity and signal indicator
6
California Prop 65 08_2018
Some dust created by power
sanding, sawing, grinding,
20 Battery pack
* depending on model

5. Initial Operation

5.1 Assembly of the additional handle
For safety reasons, always use the additional
handle supplied.
Open the clamping ring by turning the additional
handle (7) anticlockwise. Push the additional
handle onto the collar of the machine. Insert the
depth stop (8). Securely tighten the additional
handle at the angle required for the application.
5.2 Battery pack
Charge the battery pack (20) before use.
Recharge the battery pack if performance
diminishes.
The ideal storage temperature is between 10°C and
30°C.
Li-Ion battery packs "Li-Power, LiHD" have a
capacity and signal indicator (19):
- Press the button (18); the LEDs indicate the
charge level.
- The battery pack is almost flat and must be
recharged if one LED is flashing.
5.3 Removing and inserting the battery pack
Removing:
Press the battery pack release (15) button and
remove the battery pack (20).
Inserting:
Slide in the battery pack (20) until it engages.
6. Use
6.1 Depth Stop Setting
Loosen the additional handle (7). Set depth stop (8)
to the desired drilling depth and retighten additional
handle. (7)
6.2 Switching On and Off
To start the machine, press the trigger (11). The
speed can be changed at the trigger.
Release the trigger (11) to switch off.
6.3 Operating mode selection
Press (12) the lock and turn the thumbwheel (13).
Drilling
Hammer drilling
(only set if using (5) SDS chuck)
Chiselling
(only set if using SDS chuck (5))
When a chisel is fitted, only operate the
machine in the chiselling operating mode .